Apollo SL Manual de instalación Pagina 41

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 62
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 40
Specifications
Apollo SL50 / SL60 Installation Manual
33
INTERCOM PERFORMANCE (SL60 ONLY)
Microphone input ..................................... Two inputs, standard carbon or dynamic mic with
integrated preamp providing minimum 70mv rms
into 1000W load
Headphone audio output level.................. 280mW into 100W, 120mW into 500W
AGC characteristics.................................. output varies < 3db with input of 100mv rms to
1000mv rms
CONTROL INPUTS
Simulator select ........................................ Must be connected to ground for normal operation,
leave open for built-in simulator operation
Hold select................................................ Waypoint sequencing hold input, connect to
momentary button to ground for hold input
operation, should be combined with the OBS/HLD
annunciator
Transmit key (SL60)................................. Input pulled low to ground to enable the transmitter
Intercom select (SL60) ............................. Input pulled low to ground to enable the intercom
function
Flip/Flop ................................................... Remote comm flip/flop input, connect to a
momentary button to ground for remote flip/flop
operation.
ANTENNA REQUIREMENTS
GPS ANTENNA
The SL50 and SL60 are designed to operate properly with the A-33 GPS antenna. The
SL50/60 supplies 5 volts for the antenna.
COMM ANTENNA
The Apollo SL60 requires a VHF comm antenna meeting the following specifications.
Standard 50W vertically polarized antenna with a VSWR < 2.5:1.
SERIAL INTERFACE
RS-232...................................................... Defined in Appendix E - Serial Interface
Specifications
REAR CONNECTOR PINOUT
The SL60 includes two rear panel connectors, a 15 pin for the comm interface connections
and a 37 pin for the GPS navigation connections. The SL50 uses only the 37 pin connector.
The pinout for the connectors is listed in the following tables.
Vista de pagina 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 61 62

Comentarios a estos manuales

Sin comentarios