Apollo 1600 Manual de instalación

APOLLOGate Operators, Inc.Model 1500 / 1600Swing Gate OperatorINSTALLATION MANUAL03/07

10635/636 CONTROL BOARD CONNECTIONSEmergency Bypass ConnectorUsed when the control board is not functioning. Unplug themotor harness from the Master (

11635/636 CONTROL BOARD ADJUSTMENTSPROGRAM SWITCHES Factory Description Setting#1 OFF TIMER TO CLOSE - Automatically closes gateON -

12PUSH TO OPEN INSTALLATIONBoth measurements aretaken from the center ofthe hinge.11”6”Direction of openingGate (closed)Hinge postTop ViewVertical pos

13APOLLO Gate Operators RECEIVER OPTIONSDo not confuse the receiver code switches with the red program switches on the gate control board.Never set al

14TROUBLESHOOTING OPERATOR & ACCESSORIESSYMPTOMSome troubleshooting will require a hand held multimeter. An inexpensive digital multimeter may bep

15SYMPTOMGate will open using push button on side of box, but not with transmitter.1. Code switches do not match. Check that the code switches in the

16SYMPTOMGate will not open or close.Disconnect the solar panel or charger and measure the battery voltage. Battery should read 12 or more volts andne

17LIMITED TWO-YEAR WARRANTYApollo Gate Operators are warranted against defects for a period of24 months from the date of purchase, providing recommend

2CONTENTSSafety Precautions ... 3Applications ...

3WARNING - To reduce the risk of injury or death: READ AND FOLLOW ALL INSTRUCTIONS. Installation should be performed by a professional installer.

4APPLICATIONSThe Apollo Model 1500/1600 Swing Gate Operator is designed to handle swinggates up to 16 feet in length and 600 pounds each. A profession

5PRE-INSTALLATION CHECKLISTThe following checklist should be used before beginning installation:Verify that the proper operator has been selected for

6PARTS IDENTIFICATION#10025215Gate Bracket(2 with 1600)#1125Hardware Kit(2 with 1600)416EActuator with 8’ cable(416EX slave actuator with38’ cable sup

7OPERATOR INSTALLATIONLocation of Pivot Point.1/2”Center Line of attachmentpoint for gate bracketHinge postVertical positionof pivot armMeasurements a

8STEP 4 Connecting the Actuator (s)Connect actuator cable to the “MASTER” connector on thecontrol board.If a 1600 Dual Operator is being installed and

9STEP 6Limit Switch AdjustmentTo Retract MoreTurn Retract LimitScrew ClockwiseTo Retract LessTurn Retract LimitScrew Counter-ClockwiseTo Extend MoreTu